How To Cap A Basement Floor Drain

If you have a basement, then at some point you’re going to need to know how to cap a basement floor drain. Basements can be notorious for flooding, and one way to help prevent water damage is to make sure your floor drain is capped whenever it’s not in use. Here’s a quick guide on how to do just that. 1. Shut off the water supply to the basement. This can usually be done by turning off a valve in the basement or shutting off

How To Cap A Basement Floor Drain

Basement floor drains are common in homes, but they can be a little confusing to cap. In most cases, the floor drain is actually a pipe that goes through the foundation of the house and out to the street. This means that you cannot just put a cap on the end of the pipe. You will need to find the opening where the pipe comes out of the foundation and put a cap on that.

Tools: -Tape measure -Pipe wrench -Channel locks -Hack saw -Drill -1 inch hole saw -5/8 inch spade bit -Jigsaw -Caulking gun -Rags -Broom and dustpan MATERIALS: -Basement floor drain cap -PVC cement -PVC primer

• Locate the floor drain
• Purchase a rubber or neoprene floor drain cap that is the same size as the drain remove the existing drain cover insert the new drain cap
• Measure the diameter of the drain

– decide on the type of cap to use – measure the diameter of the drain pipe – purchase a cap that is the same size or slightly larger than the diameter of the drain pipe – remove the old cap from the drain pipe – place the new cap over the top of the drain pipe

Frequently Asked Questions

How Do You Cover An Exposed Drain Pipe?

There are a few ways to cover an exposed drain pipe. One way is to use a piece of hardware cloth or metal screening and attach it to the pipe with wire or screws. Another way is to use a piece of metal duct or conduit and attach it to the pipe with screws or bolts. A third way is to use a piece of PVC pipe and attach it to the pipe with PVC cement.

Can You Cap Off A Drain Line?

Yes, you can cap off a drain line. This will stop the flow of water through the line.

How Do You Cover Drain Pipes In A Basement?

There are a few ways to cover drain pipes in a basement. One way is to use a manufactured pipe cover, such as a PVC pipe cap. Another way is to use a piece of metal flashing and seal it around the pipe with caulk or roofing tar. A third way is to use a piece of scrap lumber and screw it to the wall around the pipe.

In The End

When capping a basement floor drain, it is important to use a strong and durable material that will prevent water from entering the basement. Airtight capping materials such as rubber or vinyl can be used to seal the drain. In addition, a drainage pipe should be installed to divert water away from the house.