How To Change Blade On Ridgid Table Saw
Blade changes on a table saw can be a daunting task for the uninitiated. With the right tools and a bit of know-how, however, it can be a relatively easy process. In this article, we’ll outline the steps necessary to change the blade on a Ridgid table saw.
How To Change Blade On Ridgid Table Saw
There are a few ways to change the blade on a Ridgid table saw. The quickest way is to use the blade wrench that comes with the saw. Loosen the two bolts on the front of the saw using the wrench, and then remove the old blade. Replace it with the new blade and tighten the bolts using the wrench. Another way to change the blade is to remove the throat plate from the saw. This can be done by loosening two screws on the back
-Tape Measure -Phillips Head Screwdriver -Flathead Screwdriver -Pry Bar -Safety Glasses -New Blade
- unplug the saw from the power source. 2. remove the wing nut that holds the blade guard in place. 3. lift up the blade guard and pull it out of the way. 4. loosen the
-check the manual -remove the screws that hold the blade guard in place -remove the old blade and install the new one -tighten the screws that hold the blade guard in place
Frequently Asked Questions
How Do You Change A Blade On A Portable Table Saw?
There are a few different ways that you can go about changing the blade on a portable table saw. One way is to loosen the bolts that hold the blade in place, and then remove the old blade. You can then put the new blade in place and tighten the bolts. Another way is to use a hex key to remove the blade, and then put the new blade in place and reattach the hex key.
Can You Put A Dado Blade On A Ridgid Table Saw?
You can put a dado blade on a Ridgid table saw, but you will need to remove the splitter and anti-kickback pawls.
How Do You Change The Blade On A Portable Ridgid Table Saw?
The blade on a portable Ridgid table saw can be changed by loosening the screws that hold it in place, removing the old blade, and replacing it with a new one. Be sure to tighten the screws securely before using the saw.
In The End
Changing the blade on a Ridgid table saw is a straightforward process that can be completed in a few minutes. The saw must be unplugged from the power source and the blade must be loosened before it can be removed. The new blade can then be installed by following the same steps in reverse.
