How To Change Blade On Ridgid Wet Saw

Blade changes on the Ridgid Wet Saw are a breeze. You can have the new blade installed in a matter of minutes. First, make sure the saw is unplugged and that the water reservoir is empty. Next, use the Allen wrench to remove the screw from the bottom of the saw. This will release the blade tray. Lift the tray out of the saw and remove the old blade. Be sure to dispose of the old blade in a safe manner. Install the new blade

1. Shut off the saw and unplug it from the power source. 2. Remove the water tray and set it aside. 3. Loosen the screw that holds the blade in place and remove the blade. 4. Install the new blade by reversing the steps above.

-Wet saw -Blade -Tape measure -Plyers -Marker

Remove the screws that hold the blade guard in place
Loosen the set screw on the arbor nut with a hex wrench remove the arbor nut remove
Lift the blade guard and tilt it forward

-Check the saw’s manual to see what size blade the saw can use -Determine the size of blade you need -Measure the old blade to determine its size -Remove the screws that hold the blade in place -Take out the old blade -Install the new blade by reversing these steps

Frequently Asked Questions

How Do I Change The Blade On My Wet Saw?

There are a few ways to go about changing the blade on a wet saw. The first is to loosen the bolts that hold the saw in place, remove the old blade and replace it with the new one. The second way is to loosen the clamp that holds the blade in place, remove the old blade and replace it with the new one.

How Do You Change The Blade On A Ridgid Table Saw?

There are a few ways that you can change the blade on your Ridgid table saw. The first way is to remove the throat plate and then use a wrench to loosen the nut that holds the blade in place. The second way is to loosen the bevel adjustment knob and then slide the blade out of the slot. The third way is to loosen the arbor lock and then turn the arbor nut with a wrench.

How Do You Change The Blade On A Mastercraft Tile Saw?

To change the blade on a Mastercraft tile saw, first make sure the saw is unplugged and that the switch is in the “off” position. Next, use the Allen wrench to loosen the three bolts that hold the blade cover in place. Carefully remove the blade cover and set it aside. Finally, use the Allen wrench to loosen the bolt that holds the blade in place and carefully remove the old blade. Replace the old blade with a new one, making sure to align the keyhole on the new blade with the keyhole on the saw base. Tighten the bolt that holds the blade in place and replace the blade cover. Finally, plug in the saw and turn it on to test it out.

In Summary

The process of changing a blade on a Ridgid wet saw is a relatively simple one. First, make sure that the saw is unplugged and that the blade is cool to the touch. Next, use the Allen wrench to loosen the bolt that holds the blade in place. Once the bolt is loose, remove the old blade and replace it with the new one. Make sure to tighten the bolt back up before using the saw again.

How To Change Blade On Ridgid Wet Saw