How To Dig Under Sidewalk

Under sidewalks, there is often an accessible crawl space that can be used to run wires and pipes, or to access utilities. Before beginning any digging project, call your local utility companies to mark the locations of any underground lines. To start, use a shovel to remove the top layer of soil and then use a pickaxe or spade to break up the hardpan beneath. Be careful not to damage any underground lines while digging.

How To Dig Under Sidewalk

There is no one definitive answer to this question. Some possible methods include using a shovel, a jackhammer, or a drill.

– Shovel – Rake – Wheelbarrow – Level – Tape measure – Brick or concrete saw

  • Plan the route of the dig
  • Take out any obstacles in the way, such as tree roots dig down to the desired depth add more soil to the trench as you
  • Dig a trench along the planned route

below How to Dig Under Sidewalk: -First, call your local utility company to find out where all of the underground utilities are located. It is extremely important not to hit any of these while digging. -Next, use a shovel or spade to dig a trench along the edge of the sidewalk. The trench should be at least 18 inches wide and deep enough to fit the entire width of the shovel. -Once you have dug the trench, use

Frequently Asked Questions

How Do You Bore Under Concrete?

There are a few ways to bore under concrete – one is to use a jackhammer to break up the concrete, then use a shovel to remove the rubble. Another way is to drill a series of small holes in the concrete, then insert dynamite or another explosive into the holes and detonate.

How Do You Dig A Drainage Trench Under A Sidewalk?

To dig a drainage trench under a sidewalk, one would use a shovel to dig a trench that is deep enough to accommodate the desired drainage pipe. The trench should then be lined with filter fabric to prevent soil from clogging the pipe, and the pipe should be installed. The trench should be backfilled and compacted, and the sidewalk should be repaired.

How Do You Tunnel Under A Sidewalk?

Digging a tunnel under a sidewalk is a difficult and potentially dangerous process. First, the area where the tunnel will be dug must be mapped out. Then, a hole is dug in the ground where the tunnel will be located. The hole is then extended until the tunnel is reached. The soil and rocks from inside the tunnel are then removed and transported to the surface. The process is repeated until the tunnel is completed.


There are a few ways to dig under a sidewalk – one is to use a jackhammer, another is to use a shovel and a crowbar.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *