How To Extend A Toilet Waste Pipe
If your toilet waste pipe is clogged and you can’t seem to clear it with a plunger, you may need to extend the pipe. This is a relatively easy process that can be completed in just a few hours. All you need is a few basic tools and supplies. 1. Shut off the water to the toilet by turning off the valve behind the toilet. 2. Flush the toilet to drain as much water as possible from the tank and bowl.
How To Extend A Toilet Waste Pipe
Extending a toilet waste pipe is a relatively easy task that can be completed in a few hours with the right tools and materials. The most important part of the process is ensuring that the new waste pipe is properly sealed to avoid any water leakage. The first step is to remove the old waste pipe. This can typically be done by disconnecting it from the toilet and then breaking it free from the soil pipe. Next, measure and cut the new waste pipe to size. Be sure
-Tape measure -Pipe cutter -Pipe wrench -Joint compound -putty knife -Rag -Primer -Paint
- Locate the toilet waste pipe and determine its length
- Measure and cut the desired length of pvc pipe
- Glue one end of the pvc pipe to the toilet waste pipe using pvc cement apply pvc primer to the other
-Toilet waste pipe can be extended using a coupling kit -A washer should be used to seal the joint between the pipes -Pipe insulation can be used to protect the new extension
Frequently Asked Questions
How Do You Extend The Toilet Flange After Tiling?
If the toilet flange is set in mortar and above the finished floor surface, remove the toilet and use a grinder or chisel to remove the mortar around the flange. If the flange is set in concrete, use a hammer and chisel to break it out. Then, cut a piece of PVC pipe that is 2″ less than the diameter of the opening. Slip the PVC over the flange and attach it with PVC cement. Finally, re-set the toilet and test for leaks.
How Do You Install An Extended Toilet Flange?
The installation of an extended toilet flange can be a bit tricky. The first step is to remove the old flange and clean the surface where it was attached. Then, measure the distance from the surface to the center of the hole in the floor. This is the height that you will need to cut your new flange. Once you have cut the new flange to size, use a silicone sealant to attach it to the floor. Finally, reattach the toilet bowl and test for leaks.
What Do You Do If The Toilet Flange Is Too Low?
If the toilet flange is too low, you can either raise the flange or lower the toilet.
In Closing
To extend a toilet waste pipe, one must remove the old pipe and install the new one. The process is relatively simple, but it is important to take care while working with sewage systems.
