How To Extend Pipe For Tub Spout

If the pipe for your tub spout is not long enough, you can easily extend it using a few basic supplies from your local hardware store. In this article, we will show you how to do it yourself.

How To Extend Pipe For Tub Spout

There are a few ways to extend a pipe for a tub spout. One way is to use an extension pipe, which can be found at most hardware stores. Another way is to use a coupling, which can also be found at most hardware stores. A coupling is simply a piece of metal or plastic that connects two pipes together.

-Tape measure -Pipe cutter -Pipe wrench -Soldering torch – flux -solder

  • Unscrew the old spout
  • Measure and cut the pipe to the desired length thread the new spout onto the pipe tighten the spout
  • Turn off water supply to the tub spout

on ‘how to extend pipe for tub spout’ -If the existing pipe is not long enough to reach the desired location for the tub spout, a section of pipe can be added to the existing pipe. -If the existing pipe is copper, a section of copper tubing can be added. -If the existing pipe is galvanized steel or iron, a section of galvanized steel or iron tubing can be added. -The added section of pipe should be cut to

Frequently Asked Questions

How Can I Extend My Copper Pipe Without A Solder?

There are a few options to extend copper pipe without solder. One option is to use a coupling, which is a connector that fits over the ends of two pipes and is then bolted together. Another option is to use a compression fitting, which is a connector that fits over the end of a pipe and is then squeezed together to create a seal.

How Do You Add Length To Copper Pipe?

You can add length to copper pipe by either using a coupling or a reducer.

How Do I Extend My Shower Spout?

Some shower spouts can be unscrewed and replaced with a longer one. If this is not possible, a shower extension hose can be used.

To Summarize

extending a pipe for a tub spout is a fairly simple process. First, remove the old spout and measure the length of the pipe that is extending out of the wall. Cut a piece of PVC pipe to that length and attach it to the wall with screws or anchors. Then, reconnect the spout to the pipe and screw it in place.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *