How To Fix A Broken Pipe Inside A Concrete Wall

If you have a broken pipe inside a concrete wall, the first thing you need to do is find the break. Once you’ve located the break, you will need to cut out the section of concrete around the break using a chisel and hammer. After you’ve cut out the section of concrete, use a hacksaw to cut through the pipe. Once the pipe is cut, use a pair of pliers to remove the broken piece of pipe. Then, use epoxy putty to

How To Fix A Broken Pipe Inside A Concrete Wall

There are a few ways to fix a broken pipe inside a concrete wall. One way is to cut out a section of the concrete around the broken pipe and remove it. You can then repair or replace the pipe and put the concrete back in place. Another way is to drill a hole in the concrete around the broken pipe and use a pipe-repair clamp to hold the pipe together.

-a drill -a hammer -a chisel -an awl -a screwdriver -a hacksaw -a pipe cutter -a T-square -a level -pliers -a tape measure -sandpaper -a wire brush

  • Reach inside and grab onto the broken pipe
  • Use a chisel and hammer to chip away at the concrete around the pipe until you have a hole big enough to fit your hand inside
  • Locate the break in the pipe

– Turn off the water supply to the pipe. – Locate the broken section of pipe. – Cut out the broken section of pipe using a hacksaw. – Clean any debris from the hole in the concrete wall. – Insert a new section of pipe into the hole. – Solder or glue the new section of pipe in place. – Turn on the water supply and check for leaks.


Frequently Asked Questions

How Do You Fix A Broken Pipe Under Concrete?

If a pipe is broken under concrete, the first step is to identify the location of the break. Once the break is located, a hole is drilled in the concrete around the pipe. The pipe is then cut and removed. A new pipe is installed and the concrete is patched.

How Do You Fix A Broken Pipe In The Wall?

If you have a broken pipe in the wall, you will need to fix it. You can do this by repairing the pipe or replacing the pipe.

How Do You Fix Pvc Pipe In Concrete?

You can fix PVC pipe in concrete by using a PVC coupling. The coupling will fit over the end of the pipe and then be inserted into the concrete.


In Summary

If you are experiencing a broken pipe inside a concrete wall, the best solution is to cut out the section of concrete around the pipe and replace it with a new section. This can be a difficult and expensive project, but it is the only way to properly fix the pipe.

Leave a Comment

Your email address will not be published.