How To Install A Bathtub Without Access Underneath

Installing a bathtub without access underneath can be a bit tricky, but it can be done. You’ll need to use a ladder to reach the area where you’ll be installing the bathtub, and you’ll also need some extra muscle power to lift the tub into place. Here are a few tips for installing a bathtub without access underneath: 1. Locate the studs in the wall where you’ll be installing the bathtub, and mark them with a pencil.

How To Install A Bathtub Without Access Underneath

The main obstacle to installing a bathtub without access underneath is the weight of the tub. If you are unable to lift the tub, you will need help from at least one other person. Other than that, the installation is relatively easy. Here are the steps: 1. Remove the old bathtub and dispose of it properly. 2. Make sure that the floor beneath the new tub is level and clean. 3. Place the new tub in position and mark

-Tape measure -Plywood or OSB boards -Circular saw -Chisel -Hammer -Tin snips -Paint or a sealant -Bathtub -Faucet kit -Pipe insulation -Threaded pipe connectors -Silicone caulk -Screwdriver -Drill with a ¼” bit

  • Cut through the caulk around the bathtub with a utility knife pry the bath
  • Place a bucket underneath the drain to catch any water that may leak out
  • Locate the bathtub drain and remove the stopper

-If you have a tub that is already in place and do not have access underneath, you can try to cut a hole in the floor around the tub. -If you have a bathtub that needs to be installed, it may be easier to remove the old tub before installing the new one.


Frequently Asked Questions

How Do You Access Plumbing Under A Tub?

The easiest way to access plumbing under a tub is by removing the tub drain stopper and then removing the overflow plate.

How Do You Reinforce A Floor Under A Bathtub?

There are a few ways to reinforce a floor under a bathtub. One way is to use a concrete mix and reinforce it with metal rebar. Another option is to install a backer board such as cement-fiber or Durock and then tile over it.

Does A Bathtub Need Support Underneath?

The weight of the water in a bathtub can cause it to sag or bow, so it is important to have some type of support underneath, such as a wooden frame or metal grid. Without this support, the bathtub could eventually crack and leak.


Summing-Up

Installing a bathtub without access underneath can be difficult, but is not impossible. By using a T-bar installation kit and following the instructions carefully, it is possible to install a bathtub without having to access the area beneath it.

Leave a Comment

Your email address will not be published.