How To Install Bypass Humidifier

A bypass humidifier can be a great way to regulate the humidity in your home, and they are fairly easy to install. This guide will show you how to install a bypass humidifier in your home.

How To Install Bypass Humidifier

When installing a bypass humidifier, the first step is to identify the ducts that will be used to supply and exhaust the humidified air. The ducts must be of adequate size to handle the airflow required by the humidifier. The next step is to determine where to mount the humidifier. The humidifier should be mounted as close to the point of use as possible. The unit must also be positioned so that the water supply is easily accessible and the drainage tube can

-A bypass humidifier -Tape -Pipe insulation -Screws -Drill -Jigsaw -Circular saw -Hammer -Nail gun -Level -Stud finder

  • Remove furnace front panel by unscrewing or popping off the retaining clips
  • With bracket
  • Locate humidifier mounting bracket and remove screws holding it in place
  • Before beginning installation, shut off power to furnace at circuit breaker

1. Before installing a bypass humidifier, it is important to measure the humidity levels in the room. 2. If the humidity levels are below 50%, a bypass humidifier may be installed. 3. The bypass humidifier should be placed near the heating or cooling unit. 4. The bypass humidifier should be connected to the cold water line and the hot water line. 5. The bypass humidifier should be turned on and set to the desired humidity


Frequently Asked Questions

How Do You Mount A Bypass Humidifier?

A bypass humidifier is mounted between the furnace and the ductwork. It has a water supply and a drain line. The water supply is connected to the hot water line, and the drain line is connected to the cold water line.

Can You Put A Power Humidifier On The Return?

A power humidifier can be put on the return if it is a hot water or steam humidifier. A cold water humidifier should not be put on the return because it will decrease the furnace’s efficiency.

Does A Bypass Humidifier Go On Supply Or Return?

A bypass humidifier goes on the return duct.


In Closing

To install a bypass humidifier, first identify the hot and cold water pipes that will supply water to the humidifier. Next, cut a hole in the water pipe near the humidifier and attach the bypass humidifier to the water pipes using fittings and clamps. The final step is to connect the power cord to an outlet and turn on the humidifier.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *