How To Install Check Valve On Sump Pump

A check valve is a device that allows fluid (liquid or gas) to flow in one direction but prevents it from flowing in the reverse direction. Check valves are used to prevent backflow, which could cause contamination or damage. Sump pumps often include a check valve to prevent water from flowing back into the sump pump housing and causing the pump to turn on unnecessarily.

How To Install Check Valve On Sump Pump

Installing a check valve on a sump pump is an important part of keeping your home safe from flooding. The check valve will help to ensure that the water does not flow back up the pipe and into your home if the power goes out or the sump pump malfunctions. To install a check valve on a sump pump, you will need to: 1. Shut off the power to the sump pump at the breaker box. 2. Disconnect

-A check valve for a sump pump can be bought at most home improvement stores. It is a simple device that screws onto the discharge pipe of the pump and prevents water from flowing back into the pump when the power is turned off.

  • Place the check valve over the hole in
  • Remove existing check valve, if present
  • Apply a thin layer of silicone sealant to the check valve mounting flange
  • Clean out sump pump hole and check valve mounting area

-Check valve prevents water from flowing back into the sump pump and causing it to turn on again. -The check valve should be installed on the discharge side of the pump, between the pump and the pipe leading outdoors. -The check valve should be positioned vertically, with the flap pointing down. -The check valve can be attached to the pipe with screws, clamps, or hose clamps.


Frequently Asked Questions

Where Should A Sump Pump Check Valve Be Installed?

A check valve should be installed in the discharge line of a sump pump to prevent water from flowing back into the sump pump.

How Far Above Sump Pump Should Check Valve Be Installed?

Check valves should ideally be installed 12 inches above the sump pump to prevent water from flowing back into the sump pump and causing it to become clogged.

Where Is The Best Place To Put A Check Valve On A Sump Pump?

A check valve should be placed on the intake side of the sump pump.


In Closing

A check valve is an important part of a sump pump system because it helps to prevent water from flowing back up the discharge pipe and into the sump pump system. Most check valves are very easy to install, and most come with clear instructions.

Leave a Comment

Your email address will not be published.