How To Install Everbilt Ice Maker Supply Line

Installing an Everbilt Ice Maker Supply Line is a fairly easy process that can be completed in a few minutes with just a few basic tools. The supply line is the part of the ice maker that connects the water supply to the ice maker. The supply line can be made of copper or plastic and must be the correct size for the ice maker.

How To Install Everbilt Ice Maker Supply Line

The process of installing an Everbilt ice maker supply line is relatively simple. The first step is to shut off the water supply to the refrigerator. Next, remove the old water line from the refrigerator and then remove the old ice maker from the freezer. The new ice maker supply line can then be attached to the refrigerator and the ice maker can be re-attached to the freezer. Finally, turn on the water supply to the refrigerator and check for leaks.

-Wrenches -Screwdriver -Tape measure -Pipe cutter -Pipe wrench -Hacksaw -Soldering iron -Solder

• Open the freezer door and locate the water line that runs from the back of the freezer to the front of the fridge
• Turn off the water supply to the refrigerator by closing the shutoff valve located behind the fridge

: -Check the compatibility of the Everbilt ice maker supply line with the type of water valve in your home. -Determine the length of the supply line needed and cut to fit. -Attach the compression nut and ferrule to one end of the tubing. -Push the tubing onto the valve nipple. -Secure the compression nut and ferrule with a wrench. -Flush out the system by running cold water for a few minutes.

Frequently Asked Questions

How Do I Hook Up The Water Line To My Refrigerator Ice Maker?

The water line is typically hooked up to the refrigerator’s freezer side. The ice maker line is inserted into the back of the ice maker and then pushed in until it clicks. The other end of the line is attached to the water faucet.

How Do You Hook Up A Plastic Water Line To A Refrigerator?

There are many ways to hook up a plastic water line to a refrigerator. One way is to use a T-fitting. Another way is to use a compression fitting.

How Do You Install Plastic Tubing In An Ice Maker?

To install the plastic tubing in an ice maker, one must first remove the old tubing if there is any. The new tubing must be cut to the desired length and then inserted into the appropriate fittings on the ice maker. The tubing must then be secured in place with clamps or a fitting.

To Review

To install the Everbilt ice maker supply line, first shut off the water supply to the refrigerator. Next, disconnect the old water line from the refrigerator and remove any excess water in the line. Connect the new water line to the refrigerator and reattach the water supply. Turn on the water supply and check for leaks.