How To Install Hand Held Shower Diverter

Installing a hand held shower diverter is a relatively simple process that can be completed in less than an hour. The first step is to remove the old shower head and arm from the wall. This can usually be done by unscrewing it. Once it is removed, the plumbing behind the wall will be visible. The next step is to identify which pipe is the water supply and which is the waste pipe. The water supply will be connected to the shower head, while the waste pipe

How To Install Hand Held Shower Diverter

There are a few ways to install a hand held shower diverter. One way is to use the existing shower arm and install the diverter onto that. Another way is to use a T-shaped connector to install the diverter onto the pipe coming out of the wall. The third way is to use a slide bar which can be attached to the existing shower arm or installed on its own pipe coming out of the wall.

-Tape measure -Pipe wrench -Adjustable wrench -Screwdriver -Drill -1 inch hole saw -Pipe cleaner or wire brush -Thread sealant -Teflon tape

  • Unscrew the shower head from the shower arm
  • Replace the
  • Install the new shower diverter by screwing it into the shower arm
  • Remove the old shower diverter by unscrewing it from the shower arm

-Check the size of the diverter against the size of your hand held shower hose. -If the diverter is too big, use a hacksaw to cut off the extra material. -Position the diverter so that the shower head will be pointing in the desired direction and mark where the holes will need to be drilled. -Drill the holes using a drill bit that is slightly smaller than the size of the screws that will be used to attach the diverter


Frequently Asked Questions

How Do You Install A Shower Diverter Valve?

To install a shower diverter valve, you will need to shut off the water to the shower, remove the old valve, and replace it with the new one. Then, you will need to turn on the water and check for leaks.

How Do You Replace A Shower Diverter?

The quickest way to replace a shower diverter is to shut off the water supply to the shower, unscrew the showerhead, and then remove the old diverter. You can then screw on the new diverter and reattach the showerhead.

How Do You Replace A Plastic Shower Diverter?

To replace a plastic shower diverter you will need to remove the old one and replace it with a new one. You can do this by following these steps: 1. Shut off the water supply to the shower. 2. Remove the shower head from the shower arm. 3. Remove the screws that hold the diverter in place. 4. Remove the diverter and replace it with a new one. 5. Reattach the shower head and screws. 6. Turn on the water supply and check for leaks.


To Review

A hand held shower diverter is an easy way to add a hand held shower to your existing shower. Installation is simple and can be done in a few minutes with a few basic tools.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *