How To Level Sonotubes

A sonotube is a type of cardboard tubing that is used to create a form for concrete. Sonotubes come in different sizes and are typically used to form columns, footings, and other foundation elements. To level a sonotube, you will need to use a level and adjust the height of the tube until it is level.

How To Level Sonotubes

There are a few ways to level sonotubes. One way is to use a laser level, which can be found at most hardware stores. Another way is to use a bubble level, which can also be found at most hardware stores. Another way is to use string and a weight.

-Tape measure -Level -Sonotubes -Permanent marker -Straight edge -Circular saw or reciprocating saw

  • Dig a hole in the ground deep and wide enough for the sonotubes to fit in
  • Add some concrete to the bottom of the hole
  • Place the sonotubes in the hole
  • Fill up around the

-Make sure that the sonotubes are level before you start pouring the concrete. This will ensure that the slab is level. -If you need to adjust the level of the sonotubes, use a spirit level or a carpenter’s level. -If the ground is uneven, you may need to use some type of leveling compound to make it smooth. -Once the sonotubes are level, begin pouring the concrete.


Frequently Asked Questions

Can You Leave Sonotube In The Ground?

Yes, sonotubes can be left in the ground. They are often used to form the foundation of a structure, and once they are in place they can be filled with concrete or another material to provide support.

Do You Need A Footing Under A Sonotube?

A footing is not necessary under a sonotube, but it is recommended in order to provide stability and prevent the tube from sinking into the ground. If a footing is not used, the sonotube should be buried at least 12 inches below the surface.

Can You Leave Sonotubes In The Ground?

Yes, you can leave sonotubes in the ground.


In Summary

There are a few ways to level sonotubes. One way is to use a spirit level or laser level to ensure that the tubes are perfectly horizontal. You can also use a long piece of wood as a straightedge and check that the tubes are aligned with it. Finally, you can place weight on the tubes to hold them in place while you adjust them.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *