How To Make A 37 Degree Flare

When fabricating exhaust systems, a 37 degree flare is often used to connect tubing to a pipe. This type of flare is created by using a flaring tool to create a cone-shaped recess in the end of the tubing. The pipe is then inserted into this recess and the flare is hammered into place.

How To Make A 37 Degree Flare

To make a 37 degree flare, you will need to use a protractor to measure and mark the correct angle. Next, use a ruler to draw a line at the marked angle, then use scissors or a knife to cut along the line. Finally, use sandpaper to smooth out any rough edges.

– wood glue, clamps, saw, measuring tape, jigsaw, sandpaper, drill, bit for a hole saw that is the same size as your exhaust pipe, exhaust pipe

  • Mark the spot with a sharpie
  • Take the piece of tubing and measure out how long you want it to be
  • Using a hammer and
  • Measure and mark 6 spots evenly spaced around the tubing at the mark you made

-To make a 37 degree flare, hold the tubing at a 37 degree angle and heat evenly until it begins to form a bend. -Be sure to use caution when heating the tubing as it can easily become damaged. -If using a flame to heat the tubing, be sure to keep the flame moving so that the entire circumference of the tubing is heated evenly.

Frequently Asked Questions

How Do You Make A Brake Flare?

There are a few ways to make brake flares. One way is to use a brake flare tool. This is a tool that has a cone-shaped end and a flat end. The cone-shaped end is placed over the brake pipe and the flat end is used to flare the end of the pipe. Another way to make brake flares is to use a die grinder with a grinding wheel or a cutoff wheel.

How Do You Make A Single Flare?

There are a few ways to make a single flare. One way is to use a metal stamping tool to create a design on a piece of sheet metal. Another way is to use a sharp object, like a knife or screwdriver, to make small holes in a piece of metal. The holes can then be filled with light-emitting material, like LED lights.

What Is The Correct Angle For Flaring?

When flaring a tube or pipe, the correct angle is 45 degrees.


A 37 degree flare is a type of pipe fitting that is used to connect two pipes together. It is made from metal and has a flared end that forms a 37 degree angle. The flare is used to create a tight seal between the two pipes and prevents leakage.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *