How To Make An Outside Corner With Vinyl Cove Base

There are a few ways to make an outside corner with vinyl cove base. One way is to use a vinyl cove base moulding. This is a special type of moulding that is designed to be used with vinyl cove base. It has a curved top and bottom that fit the shape of the cove base. The other way to make an outside corner with vinyl cove base is to use a mitre saw to cut the cove base at a 45-degree angle.

How To Make An Outside Corner With Vinyl Cove Base

There are a few ways to make an outside corner with vinyl cove base. The simplest way is to butt the two pieces of cove base together, and then use a seam sealant to seal the joint. Another way is to miter the cove base at a 45-degree angle, and then use a sealant to attach the two pieces together.

-Tape measure -Plywood or other straight edge material -Circular saw -Stapler -Cove base adhesive -Vinyl cove base

  • Apply adhesive to the back of the cove base stick the cove base in place
  • Cut the cove base at the marked spot
  • Measure and mark the placement for the corner
  • Cut cove base to the correct length

-Measure the length of the wall and subtract the width of the cove base. This will give you the length of the cove base needed -Cut the cove base to length with a sharp knife or scissors -Apply adhesive to the back of the cove base and adhere it to the wall starting at one end and working your way to the other. Be sure to smooth out any air bubbles as you go


Frequently Asked Questions

How Do You Cut Outside Corners On Cove Base?

There are a few ways to cut outside corners on cove base. You can use a miter saw, a coping saw, or a jigsaw.

How Do You Cut Corners On Vinyl Baseboard?

– Use a utility knife to score the vinyl baseboard where you want to cut it. – Pry the vinyl baseboard away from the wall with a pry bar. – Cut the vinyl baseboard along the scored line with a sharp knife.

How Do You Install An Outside Corner Vinyl Base?

To install an outside corner vinyl base, you will need to cut the base to fit the angle of the corner and then use adhesive to attach it to the floor.


In Summary

There are a few ways to make an outside corner with vinyl cove base. One way is to use a cove base molding that has a 45 degree angle cut on one end. Another way is to use a mitering tool to cut a 45 degree angle on the end of each piece of cove base.

Leave a Comment

Your email address will not be published.