How To Move A Toilet Drain In Concrete

There are a few ways to move a toilet drain in concrete. The easiest way is to use a reciprocating saw with a diamond blade. Cut the drainpipe as close to the floor as possible. Pry up the pipe with a prybar and remove it. Dig out the concrete around the pipe and replace it with new concrete. You can also use a jackhammer to break up the concrete and remove it, or use a drill to make holes in the concrete and break it up with

How To Move A Toilet Drain In Concrete

There are a few ways to move a toilet drain in concrete. The easiest way would be to use a jackhammer to break up the concrete and then use a shovel to remove the chunks of concrete. You could also use a drill to make holes in the concrete and then use a crowbar or pry bar to remove the chunks of concrete.

Tools: – Shovel – Wheelbarrow – Level – Tape measure – Chisel – Hammer – Pry bar – Concrete saw Materials: – Concrete mix – Sand – Gravel – Water

  • Lift the drain out
  • Use a screwdriver to remove the screws that hold the drain in place
  • Clear the area of all obstructions
  • Use a chisel and hammer to break up the concrete around the drain

-If the toilet is already set in concrete, there may be a drain underneath it. If so, the easiest way to move the drain is to cut a hole in the concrete around the drain and remove it. -Once the old drain is removed, install a new one according to the manufacturer’s instructions. Be sure to use sealant around the edges of the new drain to prevent leaks. -If there is no existing drain, you will need to create one. This can


Frequently Asked Questions

How Difficult Is It To Move A Toilet Drain?

There is no one definitive answer to this question as it can vary depending on the specific circumstances. However, in general, it can be said that moving a toilet drain is a fairly difficult task and should only be attempted by those who have experience in plumbing and drainage systems.

How Do You Move Toilet Plumbing?

To move a toilet, it is necessary to first identify the water supply and sewer lines. The water supply line is typically a copper pipe that runs from the wall to the toilet. The sewer line is typically a black pipe that runs from the toilet to the floor and then out the house. Once the lines are identified, they can be disconnected from the toilet and moved to the new location. The water supply line can be disconnected by turning off the water at the valve and unscrewing the connector. The sewer line can be disconnected by unscrewing the connectors at each end. Once the lines are disconnected, they can be moved to the new location and reconnected.

Is It Expensive To Move Toilet Plumbing?

It depends on the distance of the move and the difficulty of the installation. Generally, it costs more to move toilet plumbing than standard plumbing.


Summing-Up

To move a toilet drain in concrete, use a jackhammer to break up the concrete around the drain. Pry out the old drain with a crowbar, and insert a new drain. Use a level to ensure that the new drain is installed level, then use a concrete mixer to pour fresh concrete around the new drain.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *