How To Put A Drain In A Cooler

A drain in a cooler is an important addition, as it allows melted ice and water to be expelled from the container. This prevents the cooler from becoming overly heavy and difficult to carry, while also ensuring that the contents remain cold and fresh. There are a few different ways to put a drain in a cooler, but all require basic carpentry skills. Choose the method that best suits your needs and abilities.

How To Put A Drain In A Cooler

There are a few different ways that you can put a drain in a cooler. One way is to use a hole saw to drill a hole in the bottom of the cooler. You can then use a PVC pipe to attach to the hole and create a drain. Another way is to cut out a section of the cooler and use a PVC pipe to create the drain.

– a cooler – a drill – a jigsaw – a saw blade for metal – a screwdriver – pliers – wire cutters – a hammer – insulation tape – a tube of sealant

  • Fill the cooler with cold water and ice place the drain
  • Cut a length of pvc pipe to fit into the hole
  • Glue the pvc pipe into the hole
  • Drill a hole in the bottom of the cooler

1. When installing a drain in a cooler, it is important to make sure that the drainage system is effective in removing water from the unit. 2. One way to do this is by using a hose or pipe to direct the water away from the cooler. 3. It is also important to ensure that the drainage system does not cause any blockages or damage to the cooler.


Frequently Asked Questions

How Do You Hook Up A Cooler Drain?

To hook up a cooler drain, you will need a tube that fits over the end of the drain plug and a bucket to catch the water. Place the tube over the end of the drain plug and turn it until it is tight. Open the cooler and let the water flow out. When the water stops flowing, close the cooler and remove the tube. Put the cap on the end of the tube and place it in the bucket.

How Do You Replace A Drain Plug On A Coleman Cooler?

The drain plug on a Coleman cooler is a simple screw-in plug that can be easily replaced if it becomes damaged or lost. The plug is located at the bottom of the cooler and can be unscrewed to drain any excess water or ice.

Can You Install A Drain Plug In A Cooler?

Yes, you can install a drain plug in a cooler. This will allow you to easily drain any excess water that collects in the cooler.


To Review

Putting a drain in a cooler is a fairly simple process that can be accomplished with a few supplies and some basic carpentry skills. By following the steps outlined in this tutorial, you should be able to install a drain in your cooler quickly and easily.

Leave a Comment

Your email address will not be published.