How To Remove A Stuck Well Pump
There can be several reasons why a well pump becomes stuck and stops pumping water. A few common reasons are a clog in the water line, a broken impeller, or the pump motor has burned out. If the pump is not running, first check to see if there is power going to it. If there is power, then check to see if the pump is getting any water. If it is not getting water, then you will need to find the problem before the pump can be
How To Remove A Stuck Well Pump
Removing a stuck well pump is a difficult process, but it can be done. The first step is to try to free the pump by loosening the bolts that attach it to the well casing. If this does not work, you will need to use a breaker bar to try to break the pump free. If the pump still does not come loose, you may need to use a hacksaw to cut through the pump shaft.
-Well pump -Wrenches -Pipe wrench -Channel locks -Hammer -Pry bar -Chisel -Socket set -Screwdriver -Tape measure -Drill -1 inch hole saw
- Off valves. 2. place a bucket under the pump to catch any water that may leak out. 3. unscrew the bolts that secure
- shut off the water supply to the pump by closing the shut
-If the pump is not too badly stuck, try to free it by gently tapping on the pump with a wooden mallet. -If tapping does not work, pour a bucket of water over the pump to try and loosen it. -If the pump is still stuck, you may need to use a pipe wrench or pliers to try and free it. -If all else fails, you may have to remove the entire pump from the well in order to free it.
Frequently Asked Questions
How Do You Make A Well Pump Puller?
You can make a well pump puller using a piece of pipe and a socket. The socket should be larger than the pipe.
How Do You Remove A Stuck Water Well Pump?
There are a few ways to remove a stuck water well pump. One way is to use a breaker bar with a cheater pipe. Another way is to use a come-along winch.
How Do You Pull A Well Pump With Pvc Pipe?
To use PVC piping to pull a well pump, the piping must be securely attached to each side of the pump. Once the piping is in place, the pump can be pulled using a rope or chain.
To Review
If your well pump becomes stuck and will not turn, you can try to remove it using the following steps: 1. Shut off the power to the pump. 2. Disconnect the power cables from the pump. 3. Remove the bolts that hold the pump to the motor. 4. Lift the pump out of the motor. 5. If needed, disconnect the water lines from the pump. 6. Clean any debris from around the base of the pump. 7. Replace the bolts that hold the pump to the motor. 8. Reconnect the power cables to the pump. 9. Turn on the power to the pump. 10. Check for leaks around the water lines and repair as needed
