How To Remove A Towel Bar With No Visible Screws

There is often a hidden screw at the end of a towel bar that anchors it to the wall. If this screw is not removed, the towel bar cannot be pulled off the wall. To remove a towel bar without visible screws, use a flathead screwdriver to pry off the end cap. Once the end cap is removed, the screw will be visible and can be removed with a Phillips head screwdriver.

How To Remove A Towel Bar With No Visible Screws

There are various ways to remove a towel bar without screws. A few popular methods are listed below. One way is to use a hairdryer. Heat up the metal around the screws until it is hot enough to melt the solder. Use a screwdriver to twist the screws and then pull the towel bar off. Another way is to use a hammer and chisel. Place the chisel in between the towel bar and wall and hit it with a hammer until the chisel

-Towel bar -Phillips head screwdriver -Drill -1/8 inch drill bit -Cordless drill -Safety glasses

  • Gently pull on the towel bar to remove it from the wall
  • Locate the screws on the underside of the towel bar
  • Use a screwdriver to remove the screws

-Check to see if the towel bar is anchored to the wall with screws. If it is, use a screwdriver to remove them. -If the towel bar is not anchored to the wall with screws, it may be attached with adhesive. In this case, you will need to use a heat gun or hair dryer to heat up the adhesive and then pull the towel bar off of the wall.


Frequently Asked Questions

How Do You Fix A Towel Rack Without Screws?

You can fix a towel rack without screws by using adhesives, such as epoxy.

How Do You Replace A Towel Bar With Fixed Ceramic Ends?

To replace a towel bar with fixed ceramic ends, remove the old bar and screw in the new ones.

How Do You Remove An Old Towel Bar?

To remove a towel bar, you can use a screwdriver to remove the screws that hold the bar in place. You can then remove the bar and discard it.


Taking Everything Into Account

Removing a towel bar without screws is possible, but it can be tricky. First, try to pry the towel bar off the wall with a flathead screwdriver. If that doesn’t work, try using a drill to drill through the towel bar. Once you’ve drilled through the towel bar, use a pair of pliers to twist off the screws that are holding the towel bar in place.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *