How To Remove Barbed Fitting From Poly Pipe

Removing a barbed fitting from a poly pipe is a relatively easy process. First, use a pair of pliers to grip the barb on the fitting and twist it in a counterclockwise motion. This will loosen the fitting and allow you to pull it free from the pipe. If the barb is too tight to twist with pliers, you can try using a hacksaw to cut through the barb. Be sure to cut parallel to the fitting so that you don’t damage the pipe

How To Remove Barbed Fitting From Poly Pipe

The process of removing a barbed fitting from a poly pipe can be difficult, but there are a few ways to do it. One way is to use a pair of wire cutters to cut the barb off of the fitting. Another way is to use a pair of pliers to twist the barb off of the fitting.

-WD-40 or other penetrating oil -channel locks -vice grips -a hacksaw

  • If the fitting is still stuck, use a hammer and chisel to
  • Slide the wrenches in opposite directions to loosen the fitting
  • Take the pipe wrenches and loosen the nuts on either side of the fitting

The following are some tips on how to remove a barbed fitting from poly pipe: – Use a pair of pliers to grip the barb and twist it in the opposite direction. – If the barb is stuck, use a hacksaw to cut off the barb. Be careful not to cut into the pipe. – Use a heat gun to soften the adhesive and then pull out the fitting.


Frequently Asked Questions

How Do I Remove The Rubber Hose From My Barbed Fitting?

To remove the rubber hose from your barbed fitting, you will need to use a pair of pliers. Grip the hose tightly and twist the pliers in a counterclockwise direction.

How Do You Install Barbed Pipe Fittings?

Barbed fittings are installed by first cutting the pipe to the desired length. The pipe is then deburred and flared. The fitting is then inserted into the pipe and rotated until the barb locks into place.

How Do You Put The Rubber Hose On A Barb Fitting?

There are a few ways to put the rubber hose on a barb fitting. One way is to use a clamp. Another way is to use a hose clamp. Another way is to use an adapter.


To Review

To remove a barbed fitting from poly pipe, insert a small screwdriver or similar object into the barb and twist. The barb will loosen and the fitting can then be pulled free.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *