How To Remove Bondo

Bondo is a common name for a brand of body filler. It is a putty-like material that is used to fill in dents and scratches in cars and other vehicles. It is made of resin, wax, and hardener. Bondo can be difficult to remove because it dries quickly and becomes hard.

How To Remove Bondo

There are many ways to remove Bondo. You can use a heat gun, a hair dryer, or a steam cleaner to soften the bondo so that you can scrape it off. You can also use a chemical stripper, such as acetone, to dissolve the bondo.

-sandpaper -putty knife -paint scraper -wire brush -degreaser -acetone -enamel paint -primer -spray paint

  • Use a wire brush to clean the surface
  • Remove as much of the material as possible with a chisel or a scraper
  • Use an acetone or lacquer thinner to clean the surface apply a coat of bond

-Use a wire brush to remove any debris or loose paint from the surface of the bondo. -Apply a layer of Bondo Spot Putty to the surface and let it dry completely. -Sand the area using 120-grit sandpaper until the surface is smooth. -Apply a layer of Bondo Filler to the surface and let it dry completely. -Sand the area using 220-grit sandpaper until the surface is smooth. -Apply


Frequently Asked Questions

Does Acetone Dissolve Bondo?

Acetone is a solvent that can dissolve Bondo.

How Do You Soften Bondo Filler?

There are a few ways to soften Bondo filler. You can use a heat gun to heat it up, then use a putty knife to smooth it out. You can also add some acetone to it to help soften it up.

How Do You Prepare Bondo?

Bondo is a two-part putty used to fill and smooth out small dents and cracks in vehicles, boats, and other surfaces. It is made of resin and hardener, which are mixed together to form a putty-like substance that can be applied to the surface and then sanded down.


In Summary

There are a few ways to remove bondo. One is to use a heat gun to soften the bondo and then scrape it off. Another is to use a chemical stripper.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *