How To Remove Concrete Fence Post With Car Jack
Removing a concrete fence post with a car jack is a relatively simple process. First, use a hammer and chisel to break away as much of the concrete as possible around the base of the post. Next, place the car jack over the post and slowly raise it up until the post pops out of the ground. Finally, use a shovel to remove any remaining concrete from around the base of the post.
How To Remove Concrete Fence Post With Car Jack
Removing a concrete fence post can be a difficult task. The best way to do it is to use a car jack. Place the jack under the post and raise it until the post pops out of the ground.
-Car jack -Pry bar -Sledgehammer -Chisel -Hammer -Tape measure -Level -Circular saw -Safety goggles -Dust mask -Ear plugs
- Find a sturdy car jack
- Place the car jack underneath the concrete fence post
- Use the appropriate tool to loosen the concrete around the post remove the post from its hole
-If the concrete fence post is too heavy for you to remove by yourself, you may need to use a car jack to help. -If the car jack is not big enough to fit around the entire circumference of the post, use a piece of wood or metal pipe to give it some extra height. -Position the car jack so that it is directly under the post. -Slowly raise the car jack until the post pops out of the ground.
Frequently Asked Questions
How Do You Pull A Fence Post With Jack?
The first step would be to place the Jack in the correct position. Once it is in place, pull up on the handle to lift the Jack off the ground. Then, using a steady motion, push the Jack forward while keeping your hand on the handle. This will cause the Jack to dig into the ground and pull the fence post with it.
Can You Remove A Fence Post With A Car Jack?
It is possible to remove a fence post with a car jack. The jack can be placed under the post and then used to lift the post out of the ground.
How Do You Pull A Metal Post With A Jack?
To pull a metal post with a jack, you need to use a post jack. First, you need to measure the height of the post and then set the post jack accordingly. Next, loosen the two bolts that secure the post jack to the base. Then, insert the metal shaft of the post jack into the hole in the top of the post. Finally, tighten the two bolts to secure the post jack to the post. To pull the post, you need to raise the post jack by turning the hand crank until the metal shaft is tight against the top of the post.
To Summarize
Removing a concrete fence post with a car jack is a relatively simple process. First, loosen the soil around the post with a shovel. Next, place the car jack beneath the post and lift until the post pops out of the ground. Finally, use a hammer to knock the post off of the jack and remove any remaining concrete.