How To Remove Moen Towel Bar Without Set Screw

There may be times when you want to remove a Moen towel bar, but the set screw is missing or you can’t get it loose. In these cases, you can use a hacksaw to cut the bar off.

How To Remove Moen Towel Bar Without Set Screw

There are a few ways to remove a Moen towel bar without the set screw. One way is to use a flat head screwdriver. Place the screwdriver in the slot on the side of the towel bar and twist until it comes off. Another way is to use pliers. Grip the towel bar with the pliers and twist until it comes off.

-Tape measure -Phillips head screwdriver – Flat head screwdriver – Ruler or a straight edge – Hammer – Chisel – Safety glasses

  • Remove the decorative cap on the end of the towel bar
  • Using a phillips head screwdriver, remove the set screw that holds the towel bar in place
  • Gently pull towel bar straight down and out of the wall

-If the towel bar is held in place by a set screw, use a screwdriver to remove it. -If the towel bar is not held in place by a set screw, use a hammer and chisel to break the adhesive seal that holds it in place.


Frequently Asked Questions

How Do You Remove A Moen Towel Bar?

The steps for removing a Moen towel bar are: 1. Loosen the set screw on the side of the bar with a Phillips screwdriver. 2. Gently tug on the towel bar to loosen it from the wall. 3. If the bar is still attached to the wall, unscrew the screws at the top and bottom of the bar with a Phillips screwdriver. 4. Gently pull on the bar until it comes loose from the wall.

How Do You Release A Towel Bar?

There are a few ways to release a towel bar. One way is to use a screwdriver to twist the screws on the side of the towel bar. Another way is to use a lever or button located on the front or back of the towel bar.

How Do You Remove Anchors From Towel Bars?

There are a few ways to remove anchors from towel bars. One way is to use a chisel to chip away at the anchor until it comes loose. Another way is to use a drill to bore a hole in the anchor and then use a pliers to pull it out.


Taking Everything Into Account

Removing a Moen towel bar without a set screw is possible, but it can be tricky. You’ll need to use a wrench to loosen the nut on the back of the bar. Once the nut is loose, you should be able to pull the bar off of the wall.

Leave a Comment

Your email address will not be published.