Removing an old Moen kitchen faucet is a straightforward process that can be completed in about 15 minutes. The first step is to remove the aerator from the end of the faucet spout. Next, loosen the set screw that holds the faucet handle in place and remove the handle. Finally, unscrew the nut that connects the faucet to the sink and pull it free.
How To Remove Old Moen Kitchen Faucet
Instructions 1 Turn off the water to the kitchen faucet by shutting off the valve underneath the sink. 2 Unscrew the faucet handle from the valve stem with a wrench. 3 Unscrew the packing nut from the valve stem with a wrench. 4 Remove the old faucet from the sink. 5 Install a new kitchen faucet by following the same steps in reverse order.
-Wrench -Pliers -Channel locks -Teflon tape -New kitchen faucet
- Remove the aerator from the end of the faucet spout
- Lift the faucet off of the mounting base disconnect the water supply
- Unscrew the retaining nut at the base of the faucet
-Carefully remove the screw holding the handle in place. -Remove the handle and loosen the retaining nut. -Pull out the cartridge and remove the o-ring. -Clean off any old caulking or sealant around the faucet base. -Apply a new o-ring and reassemble.
Frequently Asked Questions
How Do You Take Apart An Old Moen Kitchen Faucet?
There are a few screws on the underside of the faucet that need to be loosened in order to take it apart.
How Do You Take The Top Off A Moen Faucet?
There are different ways to take the top off a Moen faucet, but the most common is by using a wrench. First, locate the wrench slot on the top of the faucet. Next, fit the wrench into the slot and turn it counterclockwise. Once it’s loose, you should be able to remove it by hand.
How Do You Take Apart A Moen Kitchen Faucet Head?
There is a small clip in the center of the Moen kitchen faucet head. Push down on the clip and pull the head off.
In The End
Removing an old Moen kitchen faucet is a straightforward process. First, turn off the water supply to the faucet. Then, disconnect the water lines from the faucet and unscrew the faucet from the sink. Finally, remove any remaining parts of the faucet and replace it with a new one.