How To Remove Toilet Paper Holder Without Set Screws

Removing a toilet paper holder without set screws usually requires using a drill. First, find the spot on the holder where the screws are hidden and drill a hole in that spot. Next, use a screwdriver to remove the screws. Finally, pull the holder off of the wall.

How To Remove Toilet Paper Holder Without Set Screws

There are a few ways to remove a toilet paper holder without set screws. One way is to use a screwdriver to pry off the metal plate on the back of the toilet paper holder. Another way is to use a drill to make two holes in the back of the toilet paper holder and then use a screwdriver or pliers to remove the screws.

-A screwdriver -A hammer -Potential new toilet paper holder

  • Pull the toilet paper holder off the wall
  • Locate the screws on the toilet paper holder
  • Remove the screws with a screwdriver

-If the toilet paper holder is attached to the wall with screws, use a screwdriver to remove them. -If the toilet paper holder is attached to the wall with anchors, use a drill or screwdriver to remove them. -If the toilet paper holder is attached to the wall with adhesive, use a sharp object like a screwdriver or kitchen knife to pry it off.


Frequently Asked Questions

How Do You Remove A Moen Toilet Paper Holder From The Wall?

To remove a Moen toilet paper holder, use a flathead screwdriver to pry off the cap at the top of the holder. Remove the screws and take off the holder. Reverse these steps to reattach the holder.

How Do You Remove A Glued Toilet Paper Holder?

There are a few ways to remove a glued toilet paper holder. The easiest way is to use a heat gun to heat up the glue and then use a screwdriver or pliers to pull it off. Another way is to use a hacksaw to cut the screws off and then use a screwdriver or pliers to pull it off.

How Does Moen Pivoting Toilet Paper Holder Work?

The Moen pivoting toilet paper holder is a simple design that uses a spring-loaded arm to hold the toilet paper roll in place. The arm is attached to a pivot point on the holder, so it can swing out of the way when you need to replace the roll.


Summing-Up

Removing a toilet paper holder without set screws can be a challenge, but it can be done. There are several methods that can be used to remove a toilet paper holder without set screws. The most common method is to use a pair of pliers to twist the holder off the wall. Another method is to use a screwdriver to pry the holder off the wall.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *