How To Repair Split Wood Stair Tread
Assuming the split is not too big, you can repair split wood stair treads with some wood glue and clamps. First, clean out the split with a chisel or saw. Next, apply wood glue to the split and clamp the two pieces of wood together. Let the glue dry overnight before sanding and refinishing the stair tread.
4 Steps to Repair Split Wood Stair Tread
There are a few ways that you can repair a split wood stair tread. One way is to use a wood filler. This will fill the gap and help to keep the tread together. Another way is to use a piece of wood that is the same thickness as the tread and glue it to the side of the tread. This will help to support the tread and keep it from splitting further.
One of the most important things that you can learn in regards to home improvement is how to repair split wood stair treads. This skill is important because it can help you save a lot of money and time in the long run. If you do not know how to properly repair split wood stair treads, then you will likely have to replace the entire staircase, which can be quite costly. Additionally, if you do not repair the split wood stair treads in a timely manner, then the damage will only get worse, which could eventually lead to the need to replace the entire staircase.
Step 1: Check That The Stairs Are Steady And Safe To Walk On
The first step in repairing a split wood stair tread is to check that the stairs are steady and safe to walk on. Once you have confirmed that the stairs are safe, you will need to determine the extent of the damage. If the split is minor, you may be able to repair it with wood glue. However, if the split is more significant, you will need to replace the damaged section of the stair tread.
Step 2: Assess The Damage To The Stair Tread
If the split is less than half the depth of the wood, you can simply glue and clamp the split together. If the split is deeper, you will need to clamp or tie the split together and then fill the void with a wood filler. Once the filler is dry, you can sand and finish the stairs as desired.
Step 3: Make A Temporary Repair To Secure The Stairs
Use a piece of scrap wood to support the tread while you work. Cut a V-shaped notch out of the scrap wood to fit around the riser. Attach the scrap wood to the tread with screws. Apply a generous amount of wood glue to the split. Use clamps to secure the split while the glue dries.
Step 4: Make A Permanent Repair To The Stair Tread
Make a permanent repair to the split wood stair tread by gluing and clamping the split together. Use a wood glue that is designed for exterior use and clamp the split together for 24 hours. After the glue has dried, sand the area smooth and paint or stain the stair tread to match the rest of the stairs.
Frequently Asked Questions
Why Do Stair Treads Split?
Stair treads can split for a number of reasons, but the most common cause is simply wear and tear. Over time, the pressure of people walking up and down the stairs can cause the treads to start to crack and eventually split. In some cases, this can also be caused by poor installation or using inferior materials.
How Do You Fix Split Wood On Stairs?
Use a putty knife to apply wood glue to the split. Clamp the split wood together and allow it to dry.
To Summarize
To repair a split wood stair tread, drill a hole in the middle of the split and insert a plug of wood that is the same thickness as the tread. Secure the plug with screws or nails. If the split is wide, fill it with wood glue before inserting the plug.
