How To Replace A Mixet Shower Cartridge

If your mixet shower cartridge is old, worn out, or damaged, you will need to replace it. You can do this yourself with a few tools and a little bit of know-how. First, you will need to turn off the water to your shower. Next, you will need to remove the old cartridge. To do this, you will need to unscrew the retaining nut with a wrench and pull out the old cartridge. Once the old cartridge is out, you can put the new one in. Make sure that the new cartridge is properly seated and then screw on the retaining nut. Finally, turn the water back on and test your shower.

3 Steps to Replace A Mixet Shower Cartridge

To replace a mixet shower cartridge, first remove the old cartridge from the shower valve. Next, insert the new cartridge into the shower valve and tighten it in place. Finally, turn on the water to the shower and test the new cartridge to make sure it is working properly.

One of the most important skills a homeowner can learn is how to replace a mixet shower cartridge. This simple repair can save hundreds of dollars over the cost of hiring a professional, and it only takes a few minutes to complete. By replacing the cartridge, you can extend the life of your shower and avoid the costly repairs that come with a broken shower.

Step 1: How To Identify A Mixet Shower Cartridge

To identify a Mixet shower cartridge, first remove the cap and screw from the front of the shower valve. Next, use a Phillips screwdriver to remove the two screws that secure the cartridge to the valve body. With the cartridge removed, visually inspect it for any damage or wear. The final step is to identify the size and model of the cartridge so that you can purchase the correct replacement.

Step 2: How To Remove A Mixet Shower Cartridge

To remove a mixet shower cartridge, start by shutting off the water to the shower. Next, remove the handle and escutcheon plate to access the cartridge. Use a wrench to remove the retaining nut, and then pull the cartridge out of the shower.

Step 3: How To Install A New Mixet Shower Cartridge

1. Unscrew and remove the old shower cartridge. 2. Take the new shower cartridge and apply Vaseline or plumber’s grease to the O-rings. 3. Install the new shower cartridge into the housing and tighten by hand. 4. Use an adjustable wrench to finish tightening the new shower cartridge.

Frequently Asked Questions

How Do I Change The Cartridge In My Shower?

Shut off the water to your shower. Unscrew the showerhead from the pipe, and remove the old cartridge. Insert the new cartridge into the pipe, and screw the showerhead back on. Turn on the water to your shower.

How Do You Replace A Mixet Shower Cartridge?

To replace a Mixer shower cartridge, you need to first identify the brand and model of your shower. Once you know this, you can purchase a replacement cartridge from a plumbing supply or hardware store. To install the new cartridge, you will need to remove the old one and then install the new one according to the manufacturer’s instructions.

In The End

Replace a mixet shower cartridge by following these simple steps: shut off the water supply to the shower, unscrew the old cartridge, and screw in the new cartridge.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *