How To Replace A Spud Gasket On A Toilet

If your toilet is leaking water between the tank and the bowl, you may need to replace the spud gasket. The spud gasket is a circular piece of rubber that sits between the tank and the bowl and creates a watertight seal. To replace the spud gasket, you’ll need to remove the tank from the bowl. Once the tank is off, you can remove the old spud gasket and replace it with a new one. Be sure to seal it in

How To Replace A Spud Gasket On A Toilet

Replacing a spud gasket on a toilet is a relatively easy task that can be completed in a few minutes. The first step is to remove the old gasket from the toilet spud. This can be done by using a pair of pliers to pull it off. Once the old gasket is removed, clean the spud and the area around it with a rag. Apply a thin layer of plumbers putty to the spud and then install the new gasket.

-Tape measure -Utility knife -Pipe wrench -Replacement spud gasket

  • Flush the toilet and remove the tank lid
  • Loosen the bolts that hold the tank to the bowl, and lift the tank off
  • Turn off the water supply to the toilet by turning the valve behind the toilet

below -Remove the toilet tank lid and set it aside -Locate the spud gasket and remove it -Clean the area where the gasket was located -Apply plumber’s putty to the area and press the new gasket into place -Replace the tank lid


Frequently Asked Questions

How Do You Replace A Spud Gasket On A Toilet?

Replacing a spud gasket on a toilet is a fairly simple process. The first step is to remove the old gasket from the spud. This can be done by using a screwdriver to pry it loose. The new gasket can then be installed by pressing it into place and securing it with the screws.

What Is A Spud Washer On A Toilet?

A spud washer is a small, cylindrical device that is inserted into the toilet’s siphon tube in order to clean it.

How Do You Change A Spud Nut?

The easiest way to change a spud nut is to remove the old one and replace it with a new one.


Summing-Up

Replacing a spud gasket on a toilet is a relatively easy task that can be completed in a few minutes. The most important part of the process is ensuring that the new gasket is properly positioned and that the toilet is tightly secured to the flange before applying any sealant.

Leave a Comment

Your email address will not be published.