How To Reset Ao Smith Water Heater

If you are experiencing problems with your A.O. Smith water heater, such as it not heating water or producing insufficient hot water, you may need to reset the water heater. Resetting the water heater will typically fix most common problems.

How To Reset Ao Smith Water Heater

The reset button on an A.O. Smith water heater is a small red button usually located near the lower-left corner of the control panel. This button resets the thermal cutoff switch, which is a safety device that prevents the water heater from overheating. If your water heater isn’t heating properly, resetting the thermal cutoff switch may fix the problem.

-Ao Smith water heater -Phillips head screwdriver -Wrench -Pipe wrench -Needle nose pliers -Vise grips -Hammer -Chisel -Putty knife -Tape measure -Screwdriver -Drill

  • Up pressure
  • Shut off the water heater at the breaker box
  • Turn off the cold water supply to the water heater connect a garden hose to the drain valve at the
  • Open the pressure relief valve to release any built

If your AO Smith water heater isn’t working, you may need to reset it. This can be done by following these simple steps: 1. Turn off the power to the water heater at the breaker box. 2. Wait for a few minutes for the water heater to cool down. 3. Open the pressure relief valve to release any built-up pressure. 4. Close the pressure relief valve. 5. Turn on the power to


Frequently Asked Questions

How Do I Reset My Water Heater?

You can reset your water heater by turning off the breaker to the unit, waiting a few minutes, and then turning it back on.

Do Hot Water Heaters Have A Reset Button?

Yes, most hot water heaters have a reset button. This button will restart the heater and clear any errors that may have occurred.

Where Is The Reset Button On My Hot Water Heater?

There is no reset button on a hot water heater. If the water is not hot, you may need to reset the breaker or thermostat.


To Summarize

There are a few ways to reset an AO Smith water heater. One is to press the breaker switch off and on again. Another is to press the red reset button on the upper right corner of the control panel. If these methods do not work, then it is likely that there is a more serious issue that requires professional assistance.

Leave a Comment

Your email address will not be published.