How To Separate Cast Iron Pipe Joints

Cast iron pipe joints can be separated by using a chisel and a hammer. The chisel is inserted into the joint and tapped with the hammer until the joint pops apart.

How To Separate Cast Iron Pipe Joints

Cast iron pipe joints can be separated by using a chisel and hammer. First, use the chisel to score the joint between the two pipes. Next, use the hammer to hit the chisel and break the joint.

-Wrenches -Hammer -Chisel -Pipe Cutter

  • Push the female end of the pipe into the male
  • Clean the joint surfaces of dirt, grease, and old sealant using a wire brush
  • Apply a coat of pipe joint compound to the male end of the pipe

-Use a pipe wrench to loosen the nut on the cast iron pipe -Smack the top of the joint with a hammer to break the seal -Pull the two pieces of pipe apart


Frequently Asked Questions

How Do You Remove Lead Joints From A Cast Iron Pipe?

Lead joints can be removed from a cast iron pipe by using a chisel and hammer to break the joint apart and then using a wire brush to clean the remaining pieces of lead from the pipe.

How Do You Take Apart Cast Iron Pipe Fittings?

Cast iron pipe fittings are usually taken apart by using a cast iron pipe wrench. The wrench is placed around the fitting and turned in a clockwise motion to loosen it.

How Do You Get Lead Out Of A Pipe?

There are a few ways to get lead out of a pipe. One way is to use a chemical cleaner. Another way is to use a scrub brush to clean the pipe.


Summing-Up

Cast iron pipe joints can be separated by using a wrench to twist the sections of pipe apart. The sections will usually come apart easily if they have been properly lubricated with a pipe joint compound. If the sections do not come apart easily, a little more force may be needed to break them loose.

Leave a Comment

Your email address will not be published.