How To Turn On Wall Heater Pilot

There may be times when you need to turn on the wall heater pilot. For instance, if the heater has been off for a while, the pilot may need to be lit in order to start the heater. The following steps will show you how to turn on the wall heater pilot: 1. Locate the switch that turns on the heater. It is usually near the bottom of the unit. 2. Flip the switch to the “on” position. 3

How To Turn On Wall Heater Pilot

There are a few ways to turn on a wall heater pilot. One way is to locate the pilot light switch, which is typically a small, red switch near the bottom of the heater. Another way is to use the manual override, which is a small lever located on the top of the heater. To use the manual override, pull the lever up and release it. The third way is to use the thermostat. To do this, locate the thermostat switch, which

You will need a screwdriver and a lighter.

  • Locate and remove the screw that covers the pilot light
  • Flip the switch to the “on” position
  • Find your wall heater’s switch
  • Use a lit match or lighter to light the pilot light replace the

on how to turn on wall heater -Check that the thermostat is set to “heat” -Check that the switch on the wall is in the “on” position -If there is a knob on the front of your heater, turn it to the “pilot” position -Press and hold down the ignition button while you light a match. -Once the pilot light is lit, release the ignition button. -If your heater has a digital


Frequently Asked Questions

Why Does The Pilot Light Go Out On My Wall Heater?

The pilot light on a wall heater is designed to go out after a certain amount of time. This is done so that the heater cannot be accidentally turned on and start a fire.

How Do I Light The Pilot On My Wall Heater?

The pilot light on a wall heater is typically lit with a lighter or matches. The pilot light is located near the burner and is usually a small, bright flame.

How Do You Ignite A Gas Wall Heater?

To light a gas wall heater, you must first turn off the electricity to the unit by flipping the breaker switch. Next, locate the gas shut-off valve and turn it off. Finally, use a lighter to ignite the pilot light. Once the pilot light is lit, you can turn on the gas and resume normal use.


To Summarize

light To turn on a wall heater pilot light, locate the knob at the bottom of the unit and turn it to the “pilot” position. Then use a lighter to ignite the flame by holding the flame close to the pilot light.

Leave a Comment

Your email address will not be published.